digit signal

digit signal的基本解释

-

[计] 数字信号

与digit signal相关的网络例句 [注：此内容来源于网络，仅供参考]

Record ways presented by grade four students in test question five (Divide three-digit by three-digit, can get one-digit and a three-digit, which is an inclusion division with reminder question) and test question 7 (Divide two-digit by three-digit, can get one-digit and a two-digit, which is a halved division with remainder question) of the written information are the least.

所呈现的109种记录方式为最多；四年级学童在笔试资料的第5题（三位数÷三位数＝一位数…三位数，有余数的包含除问题。）及第7题（三位数÷二位数＝一位数…二位数，有余数的等分除问题。）所呈现的29种记录方式为最少。

The main job and contribution of this paper are as follows:Based on narrowband signal processing, we propose a new method for FH signal blind detection and blind parameter estimation. Firstly, compute the cross-correlation function of FH signals from multichannels, then we get the cross power spectral density matrixCSDM Secondly, select the hops of FH signals from the CSDM via processing and analyzing the CSDM, meanwhile reduce the influence coming from noise, fixed frequency signal and other interferences; Lastly, estimating the DOA of every hop and according to the DOA, we can separate the hops, get the number of FH signals and their parameters. Propose a new method for designing the threshold in FH signal detection. This method makes it easy to get the threshold by theoretic computing and it can extremely reduce the interference of non-FH signals.Based on broadband signal processing, we propose a new method for FH signal blind detection and blind parameter estimation. Firstly, get the DOA of the signals by wideband spatial spectrum estimation; secondly, separate the signals by spatial filtering using wideband beamformer; Lastly, we propose two methods for FH signal blind detection and blind parameter estimation, one is for several constant hop-rate FH signals whose dwell-time are different and another is for a single FH signal whose hop-rate is alterable.By employing spatial interpolation in broadband signal beamforming, it can reduce the number of antenna elements and corresponding RF modules, A/D converters, etc. It can also eliminate the mutual coupling between antenna elements while getting the narrower main beamwidth and lower sidelobe level.

本文的主要研究工作和贡献如下：●提出了一种基于窄带处理的FH信号盲检测和参数盲估计的实现方法，即首先求出多路信号之间的互相关，进而得到互功率谱密度矩阵，然后通过对CSDM进行对折处理来抑制噪声、定频信号及其他干扰的影响，并将所有属于FH信号的hop(每一跳的驻留时间在时频图上持续的线段)从CSDM中筛选出来，最后用阵列信号处理中的到达方向估计理论在频域中估计出各个hop的方向参数，利用方位信息完成FH信号分离并得到FH信号的数目及其各自的参数集；●提出了一种确定FH信号检测门限的策略，该策略不仅使得检测门限能够通过理论计算得到，而且还显著地抑制了非跳频信号的干扰，从而能有效地检测出FH信号；●提出了一种基于宽带处理的短波FH信号盲检测和参数盲估计的实现方法，即首先利用宽带空间谱测向技术得到接收信号的DOA，然后采用宽带波束形成技术对特定方向进行空间滤波，实现多个信号的分离，最后分别提出了两种FH信号的盲检测和参数盲估计方法，第一种方法适用于空间某个特定方向上存在着几个驻留时间不同的恒跳速FH信号和其他干扰信号的混合信号，第二种方法适用于空间某个特定方向上仅含一个可变跳速的FH信号和噪声的混合信号；●将空间插值的概念和宽带波束形成技术结合起来，提出了一种基于频域处理的宽带恒定束宽的波束形成方法。

First, the effects of magnetic RAM relaxation time and the rise-time of incident pulse signal on reflection signal are discussed, the relationship between the rise-time of incident pulse and relaxation time based on the energy of reflection signal is revealed. Then, the effects of magnetic hysteric, susceptibilities and saturation upon reflection signal are analyzed, the results reveal the reflection of RAM target and UWB signal design. In the meantime, dielectric relaxation time effect about dielectric RAM target is analyzed simply, and the effects of relaxation time and the width of incident pulse upon reflection signal are probed. Finally, a few RAM targets are measured in the chamber using the impulse radar experiment system which is developed by the team of anti-stealth impulse radar on Department of Electrical Engineering, National University of Defense Technology. The experimental results show the similarity of the rule of echos with the theory. From the compared results of different tagets, we concluded, compared with 15% wideband sinusoidal signal, the impulse signal has increased 10～12dB energy from the same loaded RAM target; this, in turn, shows the nonlinear effects of RAM to the echoes, and the potentiality of the impulse signal to RAM targets.

首先分析了磁性RAM的弛豫时间及入射脉冲信号的上升时间对反射信号的影响，从反射信号能量角度出发，给出了入射脉冲上升时间与弛豫时间的关系；接着分析了磁性RAM的磁滞特性、磁化率及磁化强度对反射信号的影响，给出了RAM目标辐射和有关UWB信号设计的一般性结论；其次，对介电RAM的弛豫时间效应作了简单的分析，探讨了介电弛豫时间及入射脉冲宽度对反射信号的影响；最后利用国防科技大学电子技术系&反隐身冲激雷达技术研究组&研制的冲激雷达实验系统，在微波暗室中对几种不同的RAM目标进行了测量，结果表明：其反射波形的基本规律与上述理论分析相一致；从各种不同目标回波的能量对比结果得出，涂覆RAM目标对冲激信号的吸收比15％带宽的正弦信号要小10～12dB，证实了RAM的非线性效应对回波的影响，也证实了冲激信号反隐身的潜力。

与digit signal相关的网络解释 [注：此内容来源于网络，仅供参考]

acoustic signal;whistle signal：音响信号

32 闪光信号 flashing light signal;flash signal;flashing signal | 33 音响信号 acoustic signal;whistle signal | 34 手信号 hand signal

check digit, parity：配类核对数位

check digit 核对数位 | check digit, parity 配类核对数位 | check digit, sum 和核对数位

check digit procedure：校验数位程序

check digit procedure 检查数字过程 | check digit procedure 校验数位程序 | check digit 检查数字