dielectric strength

dielectric strength的基本解释

-

[化] 介电强度, 介质强度

与dielectric strength相关的网络例句 [注：此内容来源于网络，仅供参考]

In general we have two kinds of dielectric constant: the absolute dielectric permittivity, V the relative dielectric permittivity r, Vr = 0 = 1 , 0 means the vacuum dielectric constant, dielectric electrode means of EV \\ V \\ rate.

一般我们有两种介电常数：电介质的绝对介电常数，电介质的相对V介电常数r，Vr＝0＝1＋，0指真空中的介电常数，指电介质的电极化EV\V\率。

A method of production of a reduction resistant dielectric ceramic composition having a superior low frequency dielectric characteristic and further improved in accelerated lifetime of insulation resistance, specifically a method of production of a dielectric ceramic composition containing a main component including a dielectric oxide of a specific composition, a first subcomponent including a V oxide, a second subcomponent containing an Al oxide, a third subcomponent containing an Mn oxide, and a fourth subcomponent containing a specific sintering aid in a specific ratio, including a step of mixing at least part of the materials of the subcomponents excluding one or both of at least the material of the third subcomponent and material of the fourth subcomponent with the starting materials prepared for obtaining the material of the main component to prepare the pre-reaction material, a step of causing the prepared pre-reaction material to react to obtain a reacted material, and a step of mixing the materials of the subcomponents excluded when preparing the pre-reaction material with the obtained reacted material to obtain a dielectric ceramic composition.

本发明提供一种介电陶瓷组合物的制造方法，其中介电陶瓷组合物以特定的比例含有如下成分：含有特定组成的介电体氧化物的主成分，该主成分可以提供具有优异的低频率介电特性的、绝缘电阻的加速寿命进一步提高的耐还原性介电陶瓷组合物的制造方法，含有V氧化物的第1副成分，含有Al氧化物的第2副成分，含有Mn氧化物的第3副成分，以及含有特定的烧结助剂的第4副成分；该方法包含如下工序：将至少除去第3副成分的原料和第4副成分的原料的一种或两种的其它副成分原料的至少一部分，与为了得到主成分原料而准备的起始原料混合，准备反应前原料的工序；使准备的反应前原料反应而得到反应后原料的工序；以及在所得的反应后原料中，混合在准备反应前原料时除去的副成分原料，得到介电陶瓷组合物原料的工序。

The relationship between the ratio of Ca to Si with shrinkage value was needed to be studied further.The strength of M-AAS was comparatively high, but the flexural strength was regressed in the long term. The compressive and flexural strengthes of 3 days were able to surpass 8MPa and 78MPa, respectively, and compressive strength of 90 days were all around 100MPa, but compared to flexural strength of 28 days, the flexural strength of 90 days was regressed by 19.0%. The high strength property of M-AAS associated with its hydration products and Interfacial Transition Zoo. The main hydration products of M-AAS were microcline and CSH, no calcium hydroxide was found. The coexistence of microcline and CSH worked as micro-aggregate by each other, and no weak ITZ, both resulted in its high strength. The regression of its strength was related to its high shrinkage property, because the crazing caused by shrinkage would decrease the strength, especially the flexural strength.

M-AAS强度较高，但长期抗折强度倒缩。3天抗折和抗压强度分别可超过8MPa和78MPa，90天抗压强度在100MPa左右，但90天抗折强度比28天抗折强度相比低19.0％。M-AAS的高强特性与其水化产物和界面过渡区有关，M-AAS的水化产物主要为微斜长石和CSH凝胶，没有氢氧化钙，微斜长石与CSH凝胶相互填充和配合共同起到强度的作用，M-AAS砂浆中几乎没有发现界面过渡薄弱区。M-AAS的强度倒缩现象与其收缩值较大有关，收缩会引起M-AAS硬化体内部出现微裂缝，使强度下降。

与dielectric strength相关的网络解释 [注：此内容来源于网络，仅供参考]

dielectric strength：介电强度

介电强度(dielectric strength)是指单位厚度的绝缘材料在击穿之前能够承受的最高电压. 氟晶云母具有很高的介电强度和极低的导电率,在高温、高压和高频下,能保持很高的介电强度和电阻,在所应用的频带内几乎没有介电损耗,因此氟晶云母是优良的高温介电绝缘材料. 中国长春市天成氟金云母有限公司所研制的氟晶云母大晶

dielectric strength：电介质强度

dielectric strain 电介质应变 | dielectric strength 电介质强度 | dielectric strength test 绝缘强度试验

dielectric strength：绝缘强度

dielectric semiconductor interface 电介质 半导体界面 | dielectric strength 绝缘强度 | dielectric waveguide 介质波导管

dielectric strength：介质强度

Dielectric Constant介质常数. | Dielectric Strength介质强度. | Diffusion Layer扩散层.

dielectric strength test：电介质强度测试

diaphragm 膜片;隔板 | dielectric strength test 电介质强度测试 | diesel fuel tank 柴油燃料缸