die forming

die forming的基本解释

-

模锻, 型锻

与die forming相关的网络例句 [注：此内容来源于网络，仅供参考]

There are six forming methods throughcombining three different types of elements, among them, thereare four forming methods which have emblematize andpracticability: multi-point die forming、half multi-point die forming、multi-point alternating forming、half multi-point alternating forming.

对有限元模型建立及数值模拟关键算法和参数的研究在进行薄板类件多点成形的有限元分析中，涉及两类边界条件，一类是载荷，另一类是运动约束。

Barlat1989 is recommended owing to its computational effectiveness. The technique is given using the dynamic relaxation method to obtain the steady position of the blank inside die opening line from end of holder forming stage to start of die forming stage.

在板料成形过程的数值模拟研究中，提出了将动力松弛法用于获得压边圈成形结束到凸模成形开始之前凹模开口线内板料的稳定位置，从而消除动力效应的处理技术。

With corresponding complex die-cutting line of products, such as: all kinds of paper cups, yanhe, handtailor, pillow-shaped dorsal seaming, take the printed color manuscript line as it collapsed forming tools, to check whether the cutting line meets its forming the required geometry to prevent waitpending business card printing and membership card prepared to die-forming found that I cannot follow this size.

而相差驳杂的模切线的产物，如：百般纸杯、烟盒、特制盒子、枕形不面不开袋等，还需用打印不入的彩稿按其刀模线折叠成形，以查抄刀模线是否相符其成形所需的众少尺寸，避免比及制卡和会员卡制作达成给模切成形时才发掘按照此尺寸无法成形。

与die forming相关的网络解释 [注：此内容来源于网络，仅供参考]

die for first-forming：预弯模

修边模 trimming die | 预弯模 die for first-forming | 扭弯模 twisting die

die for first-forming：扭弯模

trimming die 预弯模 p0|tieD | die for first-forming 扭弯模 #dg]3|< | twisting die 扭弯模 5ldl AN'

roll forming die：辊锻模,滚压成型模具

roll forming ==> 辊形,辊轧成形,滚压成型,轧锻,轧制成形,成形轧制 | roll forming die ==> 辊锻模,滚压成型模具 | roll forming machine ==> 滚形机,成圆机