diaphragm current

diaphragm current的基本解释

-

隔膜电流

与diaphragm current相关的网络例句 [注：此内容来源于网络，仅供参考]

The problems in current increase of diaphragm electrolyzer and the countermeasures were introduced.

介绍了在隔膜电解槽电流提升过程中所遇到的问题及采取的解决方法和措施。

When a sudden power failure or accident or normal pump stops when the pump stops, the valve inlet water velocity to reduce stress Agency, the valve plate also fall, when its velocity is zero (that is, inlet flow rate is zero Department), large valve plate because of its own gravity and rapidly turn off (time 3s ~ 5s), the majority of water to prevent backflow, when the valve before and after the formation of a water pressure, water stress, on the one hand through the small valve at the bottom of the three slot for pressure relief vent pressure. 4 water stress from the bypass tube into the cavity patch up the control room (this process for the suction pressure chamber that can effectively absorb the energy of water), when water stress on cavity than inferior vena cava, the pressure of water promote the diaphragm down mobile , the current cavity pressure of water being squeezed out all the small valve plate slowly drop back to standby status, the process time to ease closure adjustable (3s ~ 150s), then the valve has been fully closed, watertight.

当突然停电或事故停泵或正常停泵时，阀门进水口处压力水流速降低，大阀板也随之下降，当其流速为零时，大阀板由于自身重力而迅速关闭（时间3s～5s），可防止大部分水倒流，此时阀门前后形成一种水压差，压力水一方面通过小阀板底部的三条泄压槽进行泄压。4）压力水从旁通管进入膜片控制室上腔（此过程为吸压腔，能有效吸收一部分水能量），当上腔压力水大于下腔时，压力水推动膜片往下移动，当下腔压力水全部被挤出来时，小阀板缓缓下降，恢复到待机状态，此过程中缓闭时间可调节（3s～150s），届时阀板已全部关闭，滴水不漏。

与diaphragm current相关的网络解释 [注：此内容来源于网络，仅供参考]

diaphragm current：隔膜电流

diaphragm gauge 隔膜压力计 | diaphragm current 隔膜电流 | diaphragm cell 隔膜电解槽