dial directly

dial directly的基本解释

-

直拨

与dial directly相关的网络例句 [注：此内容来源于网络，仅供参考]

In communications with the city of Baotou and program-controlled telephone network to dial directly to the world.

在通讯方面，与包头市并网的程控电话可直拨世界各地。

To address this situation, I believe that the operation could be improved on are: the installation and adjustment of measuring, the first sub-scale do to adjust the nominal cylinder liner size, and then dial indicator card installed and well well inserted under the initial installation of the traffic card directly into the cylinder table by measuring the smallest cylinder liner wear, the cylinder table adjust the volume of the extended length of rod inserted, so that the volume of the dial indicator cylinder table has small hands around 1.5-2.0 preloading cell volume and cylinder volume table mother under lock locking plug, the final table and then measured the volume of cylinder rod and rod card inserted at the anvil micrometer measuring bar between the seat and the large dial and adjust the dial indicator to zero.

针对这种情况，笔者认为，操作上可改进为：安装和调整量具时，先将干分尺调整到气缸套的公称尺寸，再将卡装好百分表和初步安装好插杆的量缸表直接卡入所测气缸套磨损最小处，调整量缸表插杆的伸出长度，使量缸表的百分表小表针有1.5-2.0格左右的预压量并将量缸表的插杆锁母锁紧，最后再将量缸表的测杆和插杆卡在千分尺的砧座和测杆之间并将百分表的大表盘调整到零。

The first direct measurement with micrometer piston skirt and the outside diameter Do micrometer stop screw to the locking plate position, and then dial indicator card installed and well well inserted under the initial installation of the amount of cards, directly into the cylinder corresponding cylinder kit, adjust the volume of the cylinder rod out in table inserted length, so that small hands dial indicator cell has about 1 volume of pre-press and lock locking rod inserted mother, at the same time, large dial indicator dial to adjust zero, the last cylinder to adjust the volume of good form under test card inserted rods and do at Anvil micrometer and measured the rod between the big hands dial indicator at this time than the "zero" high value is the piston and cylinder liner with the space.

3先直接用千分尺测量活塞裙部的外径并将干分尺止动螺钉扳转到锁紧位置，再将卡装好百分表和初步安装好插杆的量缸表直接卡入对应气缸套内，调整量缸表插杆的伸出长度，使百分表的小表针有1格左右的预压量并锁紧插杆锁母，同时将百分表的大表盘调整到零，最后将调整好的量缸表的测杆和插杆卡在干分尺的砧座和测杆之间，此时百分表大表针比&零&高的数值即为活塞和气缸套的配合间隙。