depth [depθ]

depth的基本解释

n.

深度, 深奥

• He ventured into the depths of the forest.
• 他大胆地走进树林深处。

• An air-raid alarm sounded in the depths of night.
• 深夜响起了空袭警报。

• What is the depth of the well?
• 这口井的深度是多少？

• The young man dived to a depth of 40 feet.
• 那个青年人潜到四十尺的深度。

• We have expressed the depth of our gratitude to them.
• 我们向他们表示了深切的谢意。

depth的同义词

n. deepness · profundity · astuteness · profoundness

与depth相关的词组

in depth：深入地

in the depth of night：在深夜

out of one's depth：非...所能理解, 为...所不及

depth所属的单词分类

Measure / 测量 [155]

square centimeter  ·  picometer  ·  picoliter  ·  megapixel  ·  cubic inch  ·  cubic centimeter  ·  cord foot  ·  square yard  ·  cubic meter  ·  nanometer

Water / 水 [131]

water well  ·  water drop  ·  snowmelt  ·  snow flurry  ·  ice pellets  ·  gravity flow  ·  H2O  ·  brackish water  ·  non-potable  ·  hydropower

与depth相关的网络例句 [注：此内容来源于网络，仅供参考]

At 135 mm depth and 0.28 m/sec speed, the biomimetic furrow opener surface with UHMWPE tubular ridges recorded 0.62 kN and 0.17 kW, while at 135 mm depth and 0.92 m/sec speed, the values were 0.91 kN and 0.82 kW. The experimental values of resistance force and power for the conventional surface furrow opener at 100 mm depth, and 0.28 m/sec speed were 0.72 kN and 0.20 kW, while at 100 mm depth and 0.92 m/sec speed, the values were 1.11 kN and 1.0 kW. At 135 mm depth and 0.28 m/sec speed, the conventional surface furrow opener recorded 0.93 kN and 0.25 kW, while at 135 mm depth and 0.92 m/sec speed, the values were 1.50 kN and 1.35 kW.

试验测试结果：当耕深100 mm和耕作速度0.28 m/sec时，实测的普通开沟器的土壤阻力和动力消耗分别为0.72kN和0.20kW；当耕深100 mm和耕作速度0.92 m/sec时，实测的普通开沟器的土壤阻力和动力消耗分别为1.11kN 和1.0kW；当耕深135 mm和耕作速度0.28 m/sec时，实测的普通开沟器的土壤阻力和动力消耗分别为0.93kN和0.25kW；而当耕深135 mm和耕作速度0.92 m/sec时，实测的普通表面开沟器的土壤阻力和动力消耗分别为1.5kN和1.35kW。

The phosphorus forms and BAP vary with horizontal and vertical positions. The total phosphorus, inorganic phosphorus, BAY, and iron-phosphorus contents were high at a depth of 0~20 cm at the first sampling point, and then decreased at 20-40 cm of depth. This shows that the potential release capacity of P at 0-20 cm of depth is higher. The concentrations of total phosphorus and inorganic phosphorus decreased at 0~20 cm of depth and increased at 20~40 cm of depth at the second sampling point, but BAY and Fe-P increased along with the depth consistently. This shows that the deeper layer at the second sampling point had a higher potential release capacity of phosphorus.

不同地点沉积物各磷形态和BAP的垂向变化有较大的差异。1号采样点的总磷、无机磷、铁磷和BAP质量比在沉积0~20 cm处较高，20~40 cm逐渐减小，说明0~20 cm内释磷潜力较大；2号采样点的总磷和无机磷质量比先减小，20~40 cm逐渐增加，而BAP和铁磷质量比随深度增加呈上升趋势，说明2点深层具有较大的释磷潜力。

The predicted values of resistance force and power for the conventional surface furrow opener at 100 mm depth and 0.28 m/sec speed were0.51 kN and0.14kW, while at 100 mm depth and 0.92 m/sec the values were0.98kN and0.88kW. At 135 mm depth and 0.28 m/sec speed, the conventional surface furrow opener recorded 0.70 kN and 0.20 kW, while at 135 mm and 0.92 m/sec speed, the values were 1.40 kN and 1.26 kW. The predicted values of resistance force and power for the biomimetic furrow opener surface with UHMWPE tubular section ridges at 100 mm depth and 0.28 m/sec speed were 0.45 kN and 0.12kW, while at 100 mm depth and 0.92 m/sec speed, the values were 0.73kN and 0.66 kW.

对于超高分子量聚乙烯材料仿生脊型非光滑结构表面，当耕深100 mm和耕作速度0.28 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.45kN和0.12kW；当耕深100 mm和耕作速度0.92 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.73kN和0.66kW；当耕深135 mm和耕作速度0.28 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.62kN和0.17kW；而当耕深135 mm和耕作速度0.92 m/sec时，预测的仿生开沟器的土壤阻力和动力消耗分别为0.91kN和0.82kW。

与depth相关的网络解释 [注：此内容来源于网络，仅供参考]

Depth：深度

Pro/ENGINEER 提供以下钻孔深度选项:"深度"(Depth) 框 - 控制"标准"孔钻孔深度. 可键入新值,或从列表中选取最近使用的值. 必须选取"可变"(Variable) 深度选项以显示此框. "深度参照"(Depth reference) 收集器 - 指示已选取了有效的对象作为"标准"孔钻孔深度参照.

Depth：全 深 比

再往下探究,Cut里有分了好多指标,个人认为比较重要的有全深比(Depth)、台宽比(Table)、腰线(Girdle)和底尖比(Culet). 这些参数指的都是钻石各部位的切割比例. 如果各部位的切割比例接近完美的话,就能够凝聚其内部所有的光线折射到精确切割的58个平面上,

Depth：高度

8、在对话框中,设置拉伸的高度(Depth)为25mm,其余各项为默认值. 点击OK,拉伸成突起特征. 注意,生成的拉伸特征已经被命名为凸台-拉伸1 ,出现在设计树中.

Depth：厚度

1-Width;2-Depth;3-Heigth;4-四方形横梁;5-圆形横梁图3.87 Top Rail结构示意图 Lower Rail(s):使用这个参数组可以控制中间的横杆的厚度(Depth)和高度(Width),单击其左边的 按钮,可以设置中间横杆的数量.

depth gauge：深度计

和调节器相连的一般还有压力表(Submersible Pressure Gauge)--让潜水员随时随地知道气瓶内的空气量,通常还会有深度计(Depth Gauge),一个额外的二级头--称为备用气源(Alternate Air Source),和一条低压充气管--此管可接合在浮力调整装置的抵押充气阀上.