coupling head
- coupling head的基本解释
-
-
联接头, 铰链
- 更多网络例句与coupling head相关的网络例句 [注：此内容来源于网络，仅供参考]
-
Pump: RCDL / RCDLF standards for the installation of the electrical non-self-priming vertical multi-stage centrifugal pumps, electrical axis through the pump head and shaft connected by coupling, rod bolts to cylinder pressure, over-current components in the pump head and out of fixed paragraph water between the pump inlet-outlet in the same line.
泵： RCDL/RCDLF为安装标准电机的非自吸立式多级离心泵，电机轴通过泵头用联轴器与泵轴联接，拉杆螺栓将耐压筒、过流部件固定在泵头和进出水段之间，泵进出水口在同一直线上。
-
Mounted coupling: first in the motor shaft mounted on the head ring, mounted on coupling half, and then in the shaft coupling client and loaded block chute and Plum wrench tightening bolts (lifting shaft 3 ~ 5 mm and to provide mechanical seal prestressed); and then loaded up the other half on the coupling screw Hexagon screw must be tightened.
装联轴器：先在电机轴头上装上挡圈，装上一半联轴器，再在泵轴端和联轴器槽内装上挡块并用梅花扳手拧紧螺栓（吊起泵轴3~5毫米并提供机械密封预应力）；再装上另一半联轴器拧上内六角螺钉必须拧紧。
-
Mounted coupling: first in the motor shaft fitted with ring head, fitted with coupling half, and then end in the shaft and the coupling block bed fitted with Plum wrench tightening bolts (lifting shaft 3 ~ 5 mm and pre-stressed mechanical seal); and then loaded onto the other half of the coupling screw Hexagon screw must be tightened.
装联轴器：先在电机轴头上装上挡圈，装上一半联轴器，再在泵轴端和联轴器槽内装上挡块并用梅花扳手拧紧螺栓（吊起泵轴3~5毫米并提供机械密封预应力）；再装上另一半联轴器拧上内六角螺钉必须拧紧。
- 更多网络解释与coupling head相关的网络解释 [注：此内容来源于网络，仅供参考]
-
coupling box：联轴器箱
coupling bolt 联接器螺栓/联结螺栓 | coupling box 联轴器箱 | Cover of front and rear head light 汽车前后灯罩
-
jaw coupling：爪型联轴器
jar coupling 震击器 | jaw coupling 爪型联轴器 | jaw of coupling head 接轴铰接叉头
-
jaw of coupling head：接轴铰接叉头
jaw coupling 爪型联轴器 | jaw of coupling head 接轴铰接叉头 | jigger coupling 电感耦合