cooling correction

cooling correction的基本解释

-

冷却修正

与cooling correction相关的网络例句 [注：此内容来源于网络，仅供参考]

In this paper the mathematical models and methods for GPS single-point positioning are studied systematically on the theory.All kinds of error correction formulas are studied,such as ironsphere correction,troposphere correction,relativistic effect correction,earth rotation correction ,earth tides correction ,satellites antenna phase center offset correction. GPS single-point positioning programs is coded with pseudoranges and broadcast ephemerides,phases and broadcast ephemerides,and phases and precise ephemerides.And a great amount of computation has been done using the data collected .The results are computed with the 24 hour pseudoranges observation data before and after the canceling of the SA.

本文从理论上系统地研究了GPS单点定位的数学模型和方法，研究了各项误差改正公式，例如电离层改正、对流层改正、相对论周期部分改正、地球旋转改正、地球固体潮改正、卫星天线相位中心偏差改正；编写了伪距与广播星历、相位和广播星历及相位和精密星历的定位程序，并使用有关数据进行了大量的计算工作。

In some conventional fan revolution speed control methods, variable control of the number of revolutions of a cooling fan is performed by a process comprising steps of detecting an actual temperature of cooling target fluid, ie fluid to be cooled by the cooling fan, such as hydraulic oil and circulating radiator cooling water for cooling an engine (such cooling water is hereinafter referred to as coolant), determining a target fan revolution speed by a system of a proportional integral control unit based on the difference between the actual temperature detected and a target temperature, and changing the fan revolution speed based on the target fan revolution speed so as to bring the actual temperature of the cooling target fluid down to the target temperature.

在一些传统风扇转速控制方法，控制变量的数目革命的一个冷却风扇，是由一个过程组成的步骤检测到一个实际温度冷却目标流体，即流体被冷却，由冷却风扇，如液压石油和散热器循环冷却水用于冷却发动机（如冷却水是以下简称为制冷剂），确定一个目标风扇转速由一个系统的比例积分控制单元基础上的差异，实际温度检测和目标温度，并改变风扇转速的基础上，针对风扇转速，使实际温度的冷却液指标下降到目标温度。

This paper hereby introduces the cooling process of the common 160,000 m^3-in-capacity atmospheric LNG storage tank in China, the preconditions and matters to which attention is paid upon the cooling of tank. It also discusses some commissioning techniques needed in the cooling process, including pressure control, cooling medium supply and its flow control, process monitoring and cooling rate control, etc. The paper points out that the displacement of pipelines is easily to be overlarge and flange leakage takes place frequently in the cooling process and it gives corresponding solutions.

为此，详细介绍了国内LNG接收站常用16×10^4 立方分尺常压LNG储罐的冷却过程，分析了LNG储罐冷却前应具备的条件及注意事项，讨论了LNG储罐冷却过程中的压力控制、冷却介质供应及流量控制、冷却过程的监控及冷却速率控制等调试技术，指出了冷却过程容易出现管线位移过大、法兰泄漏等问题，并给出了相应解决方法。

与cooling correction相关的网络解释 [注：此内容来源于网络，仅供参考]

cooling correction：冷却修正

cooling by evaporation 蒸发致冷 | cooling correction 冷却修正 | cooling curve 冷却曲线

cooling correction：冷卻改正

冷卻盤管 cooling coil | 冷卻改正 cooling correction | 冷卻曲線 cooling curve

cooling correction：却修正

539 cooling capacity 却能 ,制 能 | 540 cooling correction 却修正 | 541 cooling curve 却曲线

cooling correction：冷却改正,冷却修正

cooling conveyor rack 齿条式冷床 | cooling correction 冷却改正,冷却修正 | cooling coupling 冷却装置接头