comparable uniformity

comparable uniformity的基本解释

-

可比一致性

与comparable uniformity相关的网络例句 [注：此内容来源于网络，仅供参考]

The fluctuating deviation of bed voidage and theenhancement index of bed uniformity derived in this study can describerespectively the bed uniformity and its extent. A new criterion of demarcationof uniformity, composed of materialparameter, operating parameters (H0, u/umf) and vibrationparameters, can be used to predicting a suitable range ofbed uniformity.

对空隙率波动偏差的分析表明，振动参数、颗粒物性和操作参数均对床层均匀流化行为有不同程度的影响，且振幅和振动频率越大越能明显提高以小米或玻璃珠为物料的床层的均匀稳定性，而颗粒物性和操作参数直接影响振动能量在床层中的传播。

The simulation results of the cylinder-block model were given in the article, consistent with that of Middlemen"s. It was shown that the block part could improve the uniformity of the flow distribution. The analysis of the flow field of some materials with different power-law factor in the die designed by Mckelvey was close to that of Mckelvey"s. It was shown that the flow distribution was uniform in the die that can producesheets with 1200mm in width. During the analysis the flow channel was divided into several parts to get the details about the fluid flow in each area. A conclusion was drawn after analyzing the influence of the die pressure on the flow distribution, that the higher pressure is good for the output and bad for the uniformity of the distribution. Simulation of the die applying the cylindrical main runner showed the fact that when the cylinder replaced the cone the change of uniformity was trivial. The uniformity of the non-block flow channel was so poor that the block in the proper position of the die channel was necessary. The project of the die for the wider sheet was put forth, and the analysis of the fluid flow in the die was shown.

本文模拟了圆柱管缝隙流模型的三维流动场，得到了与Middlemen结论一致的流动均匀性，并通过模拟直观地展示了采用阻尼块可以改善挤出均匀性的现象；分析了多种幂率指数的流体在Mckelvey等人设计的流道模型中的流动分布，得到了与Mckelvey的分析结果接近的压力降和流量偏差；本文建立了1200mm幅宽机头流道的三维有限元模型，并逐个分析各个区域和多个截面的流动分布状况，由此揭示了1200mm幅宽L-型机头流道内的流北京化工大学硕士学位论文动分布基本均匀，并在分析了机头压力对于挤出流动分布的影响后得出结论：较高的机头压力可以获得较大的产量，但是不利于物料均匀分布；模拟了采用圆柱管主流道时机头流道内的流动分布，得出结论：主流道由圆锥管改为圆柱管时对流动均匀性影响不大，通过设置适当的阻尼仍然可以达到挤出平衡；模拟了两端进料式圆柱管无阻尼流道的流动均匀性后得到结论：两端进料式无阻尼结构的流动均匀性较差，宽机头中仍然有必要设置阻尼块；确定宽幅机头流道的基本方案，并设计了一种宽幅防水卷材挤出机头流道的结构，通过流动模拟表明该种结构的流动均匀性较好；考察了宽幅机头对于不同厚度片材的挤出适应性，得到结论：当生产不同厚度的片材时，阻尼块高度需要调整。

The factors of uniformity of international trade law listed in this article are nature law、the practice of 1aw merchant、globalization and international organizations,they are all contribute to the uniformity ,so the uniformity is mutualistic historical process of them.

国际贸易法可以分为公法部分与私法部分。私法部分因为是私人之间的贸易规则，所以本身就有着共同性，在主权国家出现以前它不能被称作国际贸易法，而只能被称作商人法。

与comparable uniformity相关的网络解释 [注：此内容来源于网络，仅供参考]

comparable uniformity：可比一致性

comparable topology 可比拓扑 | comparable uniformity 可比一致性 | comparison function 比较函数