collinear points

collinear points的基本解释

-

共线点

与collinear points相关的网络例句 [注：此内容来源于网络，仅供参考]

A one-dimensional calibration object consists of three or more collinear points with known relative positions.

摘要一维标定物是由三个或三个以上彼此距离已知的共线点构成的。

An example of this is specifying three collinear points to the circle fitting tool.

一个例子就是用同一条直线上的三点来拟合圆，如下图，这三点会拟合成两个半径相同的不同圆

In chapter 3, we analyzed the motion near the collinear libration points in the model of circular restricted three body problem.

前者是稳定秤动点，对定位和轨控都比较有利，而后者是不稳定的，但可以是条件稳定的，其定位条件不同于L〓或L〓处。

In addition, a method of determining second-order radial distortion coefficients based on collinear points is also presented. Comparing with previous methods, this method is much simpler.

此外，提出了基于共线的摄像机的径向二阶透镜畸变系数标定方法；和现有方法比较，新方法计算更加简单。

In this paper, cross ratios of the four collinear points and five coplanar points were analyzed first, then some affecting factors were concluded, and some constraints were proposed on constructing model-based object recognition system.

首先对共线4点和共面5点构成的交比不变量的稳定性进行了分析，得出了影响稳定性的因素，然后提出在构造目标识别系统的模型时应注意的约束条件，实验表明：在这些条件下构造模型的抗噪声能力大大提高。

与collinear points相关的网络解释 [注：此内容来源于网络，仅供参考]

collinear points：共线点

collinear diagram 列线图 | collinear points 共线点 | collinear vectors 共线向量