co-twin

co-twin的基本解释

n.

孪生兄弟(姐妹)

与co-twin相关的网络例句 [注：此内容来源于网络，仅供参考]

By use of the Fischer-Tropsch reaction in a C-H-O system, we discussed the relationships between inorganic CO〓 and some physical chemistry conditions, such as Oxygen flee degree , temperature, pressure, other objects consistency and catalyzer. a when T=200K～2000K, if f〓＞0, the reaction of generating CO〓 will be dominant, CH〓 hardily exists; b when T＞1000K, CH〓 is not propitious to exist, carbon in system almost exists in form of CO〓; c the more pressure, the more CO〓 is propitious to exist; d the more consistency of CO, O〓 and H〓O, the more CO〓 is propitious to exist, the more consistency of H〓, the more CH〓 is propitious to exist.

依据C-H-O体系费托反应的简化模型，讨论了氧逸度、温度、压强、其它物质浓度、催化剂等物理化学条件对无机成因CO〓生成的影响，从理论上讨论了在地质环境中，无机成因CO〓存在的物理化学条件：1在T＝200K～2000K的温度范围内，体系中一旦氧逸度＞0，生成CO〓的反应将占绝对优势，CH〓几乎不可能存在；2T＞1000K时，不利于CH〓形成，使体系中的碳主要以CO〓的形式存在；3体系压强越大，越有利于CO〓的形成；4反应物CO、O〓、H〓O的浓度越高，越有利与CO〓的存在，H〓的浓度高有利于CH〓的形成。5地质成藏作用可以经历很长的地质年代，这足以补偿矿物岩石中的Ni、Mo、Fe、Co、Ru等催化性能的降低及其它动力学条件的不足，使得费托反应可能发生，从而生成无机成因的CO〓和烃类。

It was found that Pd-Co/active carbon catalyst was the optimal catalyst, and Pd-Co/γ-Al2O3 was also good, but silica and kieselguhr were not proper carriers for the object reaction, because of their stronger surface acidity, which could result in the formation of polymer, jammed the micro pores of catalyst, and then resulted in its deactivation. Addition of Bi, Ce and Cu promoters could not improve the activity of catalyst, but La and Ba promoter could enhance the activity of catalyst apparently, and the Co was the best promoter, especially Co was impregnate in advance. It was attributed to that the pre-impregnated Co may occupy the micro pores of active carbon, and cover some bad functional groups on the surface of catalyst, so that the active and selectivity of catalyst could be enhanced obviously.

研究结果表明，Pd-Co/活性炭催化剂是目标转移加氢反应的最适宜催化剂，Pd-Co/γ-Al203效果也较好，而硅胶和硅藻土由于表面酸性较强，容易造成生成聚合物而堵塞催化剂微孔、使催化剂迅速失活；此外，添加Bi、Ce、Cu等助剂时对活性并无改善作用，而添加La和Ba助剂时可使Pd的催化活性有所提高，效果最好的是Co助剂，尤其是先浸渍Co的Pd-Co/C催化剂，原因是Co占据了活性炭的微孔、覆盖了某些对目标反应不利的官能团，使其活性和选择性都有较大幅度的提高。

The conclusions were as follows: theνO-H andνC=O IR absorption maxima shifted towards higher wave numbers after imprinting 17β-estradiol on TFMAA-co-TRIM copolymer with the red shift of theνO-H groups being apparent after precipitation polymerization for 16h while that forνC=O groups being observed after polymerization for 24h. A strong interaction between TFMAA and 17β-estradiol was confirmed by the high selectivity for 17β-estradiol, as indicted by the values of the separation factor of isomers of 17β-estradiol/17α-estradiol (2.28) and the imprinted factor (3.01). Particle diameter of TFMAA-co-TRIM polymer was between 300 nm and 1.5μm, which suited well for solid phase sorbent throughout at low column pressure. The recognition of imprinting TFMAA-co-TRIM polymer for sterol molecules was driven by enthalpy eluted with acetronitile, and low temperature was in favor of the separation of sterol structure analogues on imprinting column. TFMAA-co-TRIM polymer possessed of determinate anti-heat stability, with melting point beginning at 255.84℃, Tp=257.40℃, control TFMAA-co-TRIM polymer and imprinting TFMAA-co-TRIM polymer were respectively decompounded at 267.79℃and 343.11℃, and solid micro-extraction noddle prepared by the special polymerization also showed definite recognition for 17β-estradiol by GC/MS detecting at 270℃. By selection of various washing and elution solvents, elution reagents of close polymerization system were of more advantage in template molecules retention and recognition on molecularly imprinted solid phase extraction column. At a certain extent, progesterone, 17α-estradiol, 17β-estradiol and 4-androstene-3, 17-dione could be intercepted on the MISPE column. Especially, MISPE had high selectivity for progesterone, and imprinting TFMAA-co-TRIM polymer could achieve adsorption balance within 50 min by absorption kinetics test for 17β-estradiol. However, MISPE column showed better selectivity and enrichment property for 17β-estradiol than C18 and CSPE columns according to the data from HPLC and GC/MS analyses. Recovery of 17β-estradiol on MISPE column was up to 85.5% while when prime extracting solution of milk powder was sampled, the recovery of CSPE and C18 columns were 43.7% and 30.7%, respectively.

通过研究阐明：紫外聚合产物TFMAA-co-TRIM中的νO-H振动吸收峰在聚合16h后红移，νC=O振动吸收峰在聚合24h后红移；TFMAA-co-TRIM对雌二醇异构体的印迹因子达到了3.01，α为2.28，优于其它功能单体参与得到的聚合物识别特性；TFMAA-co-TRIM聚合物粒径介于300 nm至1.5μm之间，作为色谱固定相具有良好的通量和低的柱压；在乙腈流动相中，TFMAA-co-TRIM分子印迹固定相的分离过程主要被焓驱动，低温有利于分子印迹固定相分离甾醇结构类似物；TFMAA-co-TRIM分子印迹聚合物在255.84℃时开始熔融，Tp=257.40℃，聚合物CP的降解温度在267.79℃，MIP降解温度在343.11℃，制备的固相微萃取头初步经GC/MS 270℃的耐热性测定；不同的洗提溶剂筛选证明了选择接近聚合溶剂的洗脱体系更有利于MISPE发挥识别效应；分子印迹固相萃取柱对孕酮、17α-雌二醇、17β-雌二醇和雄烯二酮都具有不同程度的保留特性，可作为此类化合物的吸附材料，特别对孕酮强保留的富集特性，可作为孕酮的选择性识别吸附剂，其分子印迹聚合物对17β-雌二醇的吸附动力学测定显示在50 min内基本达到吸附平衡，具有作为传感器核心敏感材料的潜力；对比萃取奶粉中17β-雌二醇性能，MISPE柱比非分子印迹固相萃取柱和C18柱具有更高的保留，回收率依次为85.5%，43.7%和30.7%。

与co-twin相关的网络解释 [注：此内容来源于网络，仅供参考]

co-author co-chair co-pilot co-founder：共同(做某事)

centi- 百分之一,百 centimeter centigram centiliter centigrade | co- 共同(做某事) co-author co-chair co-pilot co-founder | counter- 反 counter-measure counter-attack counter-strike

co-exist, co-operate, co-education：共同

re 重复,再 rewrite, remarry, reunite, recycle, | co- 共同 co-exist, co-operate, co-education | ex 以前的 Ex-husband, ex-president

KALR Reconciliaton Ledger: CO Line Items：对帐分类帐:CO行项目

KALO Export Reconcil. Ledger (Rollup) 出口调整分类帐 (累加) | KALR Reconciliaton Ledger: CO Line Items 对帐分类帐:CO行项目 | KALS Cancel Reconciliation Posting 取消对账的过帐