clamping head
- clamping head的基本解释
-
-
夹头
- 更多网络例句与clamping head相关的网络例句 [注：此内容来源于网络，仅供参考]
-
How to do this is: the series-water roll clamping in grinder, head of the bed with a fixed Center, bed end, respectively, with huoluo thimble, despite a string of water both ends of the roll Center always ends up in l, with a dial check and correction of water roll radial runout of excircle and the tiaodong of error control in 0.02mm, to achieve accuracy requirements.
抽象操纵为：把串火辊夹持在磨床上，床头用变动顶针，床尾用方活顶针，分别顶住串火辊两头的边缘孑L，用百分表查抄和订正火辊外方的径向跳动度，并把跳动度的差错把持在0.02mm不以外，使其到达不粗度请求。
-
At all times,special equipments that are used to process boiler and oil cylinder head plates,has limitations of various clamping fixtures and difficulties in processing at large.
一直以来，用于加工锅炉和油缸封头的专用设备普遍存在胎具繁多、加工困难的缺陷。
-
Labeling process is in line with the COTS and squeege formed the COTS guaranteed cutan, when the charts after gelatinize cots and when you turn the subject box of the front end to scroll in the form of stick out a label; with a label of panels continue to campaign,张合 by 揭标-揭标 e-?·|-clamping of the label side margin was off, when the then standard barrel go to one side of the bearing bottle turntable with Mark intracavernous when the aluminum foil on the bottle labels; at the same time the label of the bottle with the cap bottles go taiqian line also with the pallet for the 90-degree rotation, across the brushlelss label group label is brushlelss; the last high school marching to starred on the head part of applanation.
贴标过程是胶辊和刮板配合使胶辊上形成一定厚度的胶膜，当标板经过胶辊时涂胶并在转过标盒前端时以滚动形式粘取出一张标签；带着标签的标板继续运动，由揭标筒的张合揭标指夹住标签侧缘而被揭下来，当接标筒转到承瓶转台一侧时通过压标海绵将铝箔标贴到瓶口上身标同时贴上）；贴了标签的瓶子随承瓶转台前行的同时还会随托盘作90度旋转，穿过刷标组时标签被刷平；最后行进到压标星轮上将盖顶部分压平。
- 更多网络解释与clamping head相关的网络解释 [注：此内容来源于网络，仅供参考]
-
clamping fixture：夹具
clamping filter 箝位滤波器 | clamping fixture 夹具 | clamping head 夹头
-
Collet chuck head：弹簧夹头,套筒夹
Collet chuck 弹簧夹头,套爪卡盘 | Collet chuck head 弹簧夹头,套筒夹 | Collet clamping head 弹簧夹头