charging box

charging box的基本解释

-

加料箱, 加料槽, (平炉的)装料箱

与charging box相关的网络例句 [注：此内容来源于网络，仅供参考]

This designed proposal can realize continuous and uniform coal distribution into coal box of the charging car, it is characterized by less capital construction investment, less difficulties for construction and east for maintenance.

该设计方案可对装煤车的煤箱实现连续均匀布煤，具有基建投资少、建设难度小、维护方便等特点。

Based on the work flow of charging equipment, three worst work conditions of the clack box were defined. Then, based on thermal-structure coupled theory, the thermal-structure coupled of the clack box which suffered from mechanical and temperature load was analyzed using the powerful software ANSYS. The clack box's temperature field and stress field as well as the stress spectrum of danger area in actual working condition were obtained. Finally, based on crack initiation and crack extension theory, the clack box's fatigue life was predicted.

摘 要：根据装料设备的工作流程，确定阀箱3种最不利的载荷工况；基于热－结构耦合理论并利用有限元分析软件ANSYS研究阀箱在温度载荷和机械载荷作用下的热－结构耦合问题，得到实际工况下阀箱的温度场、应力场以及危险部位的应力谱；依据裂纹萌生和扩展理论对阀箱进行疲劳寿命预测。

Semi-automatic balers: hydraulic-driven models are used, choose manual or automatic operation of PLC; hydraulic pump output oil pressure up to 21Mpa (210Kg/cm), oil cooling system with heat exchanger air cooling; installed without bottom feet screw, only the machine placed in the ground formed a good level of adjustment can be used; strapping manually adjust the length, packing for the manual form, the package automatically push out the package for the direct form; body organizations to adopt quality carbon structural steel welding system, base bottom and front gate feed additional wear plate to ensure durability; moving blade (V type SKD-11 resistant steel knife); push pressure from 100 to 250 tons with four levels, productivity, 4 tons / hour; charging box size and mass, shape and size can be customized according to user specifications and design materials.

半自动打包机：机型均采用液压驱动，可选择手动或PLC自动控制操作；油压泵输出油压最高达21Mpa（210Kg/cm，系统油液冷却采用热交换器风冷却；安装无须底脚螺丝，只须把机器安放在平整地面调校好水平便可使用；捆包长度为手动调整，捆包为手动形式，出包为直推自动出包形式；机体机构采用优质碳素结构钢焊制，机座底部及前方进料闸门附加耐磨钢板确保经久耐用；活动式裁刀（V型式SKD-11耐磨钢刀）；推压力从100吨至250吨有4个等级，生产率4吨/小时左右；加料箱尺寸和包块形状尺寸可根据用户原料规格设计定制。

与charging box相关的网络解释 [注：此内容来源于网络，仅供参考]

casting box for curred stereos：曲面铅版浇铸机

airglow excitation 大气辐射激励 | casting box for curred stereos 曲面铅版浇铸机 | dribble charging 带球撞人