case-lawyer

case-lawyer的基本解释

-

[法] 精通案例的律师

与case-lawyer相关的网络例句 [注：此内容来源于网络，仅供参考]

The theory of high-strain dynamic testing of pile bearing capacity. The basic calculation expression of pile high-strain dynamic testing is rederived in a simple way, especially the semi-empirical analytical expression of wave equation . Besides, theoretically it has been proved that it's not necessary to have identic section hypotaxis along pile, and the application condition and reasonable operation have been pointed out. the CASE comprehensive method is suggested to replace the traditional CASE method. author has made a lot of improvement for the mathematical model of the matching analysis measured curves in the business software CCWAPC and scientific research software JXWAPC of which the author is in charge.

关于高应变动力试桩法的理论研究以简明方式重新推导了高应变动力试桩法基本计算表达式，尤其波动方程半经验解析表达式，同时从理论上证明了CASE法并不需要桩身等截面假设，亦指出了该方法的适用条件及合理使用办法，并建议利用CASE综合分析法取代传统的CASE分析法；作者在其负责编制的商业软件CCWAPC及科研软件JXWAPC中，对波动方程拟合分析法数理模型进行了一系列重大改进，考虑了灌注桩桩周土体的变形特性和动荷截作用下的非线性效应、大直径桩的横向惯性效应。

By now I hope you've read Case 1: Basic Indexes and Case 2: Table Design and Index Details so we'll jump straight into the action.

到现在为止，我希望你已经读了Case 1： Basic Indexes and Case 2： Table Design and Index Details。所以我们直接去优化。

The objectives of this paper were to investigate the simulation and design of continuous multiple-station rolling forming process for a U-Section Steel Bar by CAE software-DEFORMTM Due to the limitation of elements number using a short strip 120mm went through all the stations to simulate the real continuous rolling forming on factory The roller gap was fixed as 0 30mm roll speed was 20 rad/sec and progressive angles were all equal for each rolling process which were the formed angle divided by by the number of station Three rolling processes were selected with 6 9 and 12 stations respectively During simulation processes two cases occurred Case A the strip was through a single station Case B the strip across two stations Because the strip laterals side was stretched and twisted during the process The model of case B closer to the practical process than case A and the calculated stress and strain on the tip of U section for case A were lower than these for case B by up to 15% From the result of case B for each process the stress for 12-station process was smallest 9-station process second and 6-station process next Because less-station can save larger cost and forming time but the bigger stress and strain for 6-station caused wrinkles on lateral sides not found on 9-station and 12-station Therefore 9-station process was a more suitable design than 12-station process smaller stretched and twisted and stress The progressive angles for 12-station was 7 5?

本文主要是以DEFORMTM有限元素软体模拟U型钢片连续道次成型与单一道次成型以确认单一道次模拟的是否可取代连续道次模拟之研究。因DEFORMTM 软体对於网格元素上的限制故使用较短素材120mm通过所有的成型站以模拟工厂实际连续成形方法。辊轮间隙固定为0 3mm；辊轮转速为20 rad/sec；弯曲角度的方法为将成型角度平均除以成型站数。有三种辊轮成型方式被选择分别为6站，9站，与12站。在模拟的过程中有两种现象会产生 Case A，素材通过单一成型站。Case B，素材会通过两个成型站。因为在模拟过程中素材的两端会有拉应力与扭力。Case B的模拟比Case A像实际的制程，并计算应力与应变在U型断面的Tip部中可发现Case A比Case B低约15%。从Case B的每站的结果可以得知，12站的成型应力最小，9站次之，6站最后。

与case-lawyer相关的网络解释 [注：此内容来源于网络，仅供参考]

CASE：case n

58. be regarded as 视为 | 60. case n.事, 病例, CASE, 情形, 场合, 讼案, 容器, (语言规则)格 | 61. literature n.文学(作品), 文艺, 著作, 文献

in any case=at any rate：不管怎样,无论如何; in no case 决不

11. shut off 关上,停止,切断 | 12. in any case=at any rate 不管怎样,无论如何; in no case 决不 | 13. or so 大概,大约

不管怎样,无论如何; in no case 决不：in any case=at any rate

11. shut off 关上,停止,切断 | 12. in any case=at any rate 不管怎样,无论如何; in no case 决不 | 13. or so 大概,大约