brazing seam
- brazing seam的基本解释
-
-
焊缝
- 更多网络例句与brazing seam相关的网络例句 [注：此内容来源于网络，仅供参考]
-
The results show that heating at1500oC for 10 minutes in vacuum is the best brazing process. In the ceramic side none defects was observed at the interface of ceramic and solder, which leads to uniform brazing seam and excellent airtightness.
本文对单晶Al2O3/Pd/Nb焊接工艺、界面组织结构等进行了研究分析，结果表明在真空状态下，温度为1500℃，保温10分钟得到的焊缝均匀一致，没有任何的孔洞缺陷，气密性检测说明焊接情况良好。
-
The brazing seam mass is therefore good and bad the mass being related to a weldment is good and bad , mass that can affect to weldment sigmatism function , how to raise therefore, we answer a brazing seam carries out the analysis studying.
因此焊缝的质量好坏关系到焊件的质量好坏、会影响到焊件的使用性能，所以，我们应对如何提高焊缝的质量进行研究分析。
-
As the brazing temperature was low or the holding time was short, lots of low-melting M3B2 were precipitated in the central part of the brazing seam.
当钎焊温度较低或保温时间较短时，钎缝中央生成大量的M3B2；随着钎焊温度的升高及保温时间的延长，钎缝中M3B2、MC减少，M23C6增多、长大。
- 更多网络解释与brazing seam相关的网络解释 [注：此内容来源于网络，仅供参考]
-
braze metal：钎缝金属
钎缝 brazing seam; soldering seam | 钎缝金属 braze metal | 钎角 fillet
-
joint gap; joint clearance：钎焊间隙
钎焊面 faying face | 钎焊间隙 joint gap; joint clearance | 钎缝 brazing seam; soldering seam