barrel assembly

barrel assembly的基本解释

-

炮身, 枪管

与barrel assembly相关的网络例句 [注：此内容来源于网络，仅供参考]

Rifle can be disassembled without any special tools in about 60 seconds; after basic disassembly, user can replace upper receiver / barrel assembly and bolt to change caliber as necessary.

步枪可以在不拆卸任何特殊工具在大约60秒；基本解体后，用户可以更换机匣/桶集会和螺栓改变口径必要的。

The number of strokes of the syringe plunger before the stopper is locked into the barrel rendering the syringe assembly unusable is determined by the number of detents on the plunger rod and stopper which engage the locking mechanism.

注射器柱塞在制动器锁入针筒从而使注射器组件失效之前的冲程次数，由啮合锁定机构的柱塞杆和制动器上的定位器数目来确定。

Injector fuel supply or pressure is not enough, atomization bad, drip, etc.; plunger rod adjustable arm or teeth protruding ears from the governor lever fork slot prolapse in non-oil position; fuel pump plunger and barrel assembly seriously wear and tear, oil pressure is too low, the oil valve wear serious Mifengbuyan; washer crack and deformation, a broken valve spring, injector wear and tear stuck in the closed position.

喷油器不供油或压力不足、雾化不良、滴油等；柱塞调节臂或齿杆凸耳从调速杠杆叉槽中脱出处于不供油位置；喷油泵柱塞偶件严重磨损，供油压力太低，出油阀磨损严重，密封不严；垫圈开裂变形，出油阀弹簧折断，喷油器磨损卡死在关闭位置。

与barrel assembly相关的网络解释 [注：此内容来源于网络，仅供参考]

plugged filter：堵塞的滤清器

plugged 堵塞的 | plugged filter堵塞的滤清器 | plunger and barrel assembly 柱塞偶件

double pole single-throw switch：双刀-单掷开关

double-pole double-throw switch;双刀-双掷开关 | double-pole single-throw switch;双刀-单掷开关 | double-pump barrel assembly;双泵筒[体]总成

barrel arch：筒形拱

barrel arbor ==> 条盒心轴,卷筒轴 | barrel arch ==> 筒形拱 | barrel assembly ==> 炮身