approximate treatment
- approximate treatment的基本解释
-
-
近似计算
- 更多网络例句与approximate treatment相关的网络例句 [注：此内容来源于网络，仅供参考]
-
At first step, the processor before the deformable body contact the end face of cone die cavity regarded as an extrusion process. The minification of core boss's cross-section regarded as compressibility of direct extrusion, which acted as definition factor when construct the Direct Extrusion Model element. Another step, the model element of flat punch extrusion on wedge piece process was constructed when propose the process of deformable body overflow die corner. In this way the spherical end face of blank looked as cone end face one, t he approximate treatment is one of originality innovation in this paper. At last, the two elements have been connected and constructed the model element of cone boss part's deformation in the open die forging.
对于锥形凸台成形的第一个特征时段，即坯料和锥形凸台型腔的端面接触之前的变形过程，本文将凸台的截面缩小率转换成挤压成形的压缩率并以此为界定，建立了不同截面缩小率时的锥形模正挤压的模型单元；对于锥形凸台成形的第二特征时段即锥形模的角部充满过程，在详细考察锥形型腔端面对变形过程影响的基础上，将变形体的球形端面近似成锥面建立了平冲头挤压楔形体的模型单元；最后将前述两种模型单元有机连结，构建了开式模锻中整个锥形凸台成形过程的定量描述。
-
By means of a resonable and approximate treatment the dependent variables of the integral equation are reduced to depend only on the two coordinates of the wing plane.
通过合理的近似处理，使积分方程的自变量仅依赖于机翼所在平面的两个座标，这就使我们在利用有限无法进行数值解时，只需在机翼平面上划分元素，避免了在流场空间中划分元素的传统作法，从而大大降低了对计算容量的要求和计算工作量，使跨音速三维机翼的气动力计算有可能在较小的计算机(例如709机)上完成。
-
Firstly, this paper uses the method of renormalization group to deal with the Ising Model of equilibrium phase transition and calculate and compare the critical index of the model of square cell with different lattices, which leads to the finding that the size of Kadanoff cell have greater influence on the approximate treatment of interactions between cells.
本文首先用重正化群方法处理了平衡相变的Ising模型，计算了不同格点数的正方形元胞模型的临界指数并进行对比，发现Kadanoff 元胞的大小对元胞间相互作用的近似处理影响较大。
- 更多网络解释与approximate treatment相关的网络解释 [注：此内容来源于网络，仅供参考]
-
approximate value：近似值, 概算价值
approximate treatment | 近似计算 | approximate value | 近似值, 概算价值 | approximate | 近似的, 大约的 近似, 接近, 接近, 约计