allowable error

allowable error的基本解释

-

[化] 允许误差, 允差

与allowable error相关的网络例句 [注：此内容来源于网络，仅供参考]

It also can be used to measure the geometrical tolerance, such as straightness error, roundness error, cylindricity error, parallelism error, perpendicularity error, angularity error, coaxiality error, symmetry error and circular run-out error etc.

该仪器集机、光、电于一体，采用了新的光路系统和近些年最新的测量方法及数据处理方法，具有功能多、体积小、重量轻、操作方便、非接触测量、测量精度高等特点。

In this paper, some characteristic functions of the multifunctional single-flank mesh gear tester of model CD320G-D which is applying gear integrated error measuring technique, computer technique, error separation technique, fault diagnosis technique and error prediction technique, including automatic searching of profile error start point, determination of profile barrelling, separation of profile form error and profile slope error, measurement of profile error with evaluation range subtracting tooth tip, measurement of tooth topograph and statistical analysis of gear manufacture error, are presented.

阐述了综合应用齿轮整体误差测量技术、计算机技术、误差分离技术、故障诊断技术和误差预报技术的多功能 CD320G-D 型单啮仪的一些具有特色的功能。这些功能包括齿形误差起测点的自动找定、凸形齿凸形量的测定及其形状误差与倾斜误差的分离、取值范围扣除齿顶部的齿形误差的测量、齿面轮廓度误差的测量以及齿轮加工误差的大样本统计分析。

As for the factitiously specified allowable values,such as allowable deflection,allowable amount of wear,and so on,their magnitudes,which are confirmed on the basis of empirical formula,often have an interval value or a limit value,therefore they can be described suitably by minor type membership function, As for various strength values of parts,such as tensile strength,compression strength,contact strength and so on,their magnitudes,which are often confirmed only by approximate mean,can be described suitably with middle type membership function.

对于人为规定的各种许用值，如许用挠度值、许用磨损量等，根据经验公式确定它们的大小时往往有一个区间或一个极限值，宜用偏小型隶属函数描述，对于零件的各种强度值，如抗拉强度、抗压强度、接触强度等，实际中往往只能确定其近似的均值，宜用中间型隶属函数描述。

与allowable error相关的网络解释 [注：此内容来源于网络，仅供参考]

allowable error：容许误差

allowable concentration 许容浓度 | allowable error 容许误差 | allowable load 容许负载

allowable error：容许~差

"同素变态","allotropy" | "容许~差","allowable error" | "容许重 ","allowable limit"

allowable error：允许误差

allowable defect 允许缺陷 | allowable error 允许误差 | allowable load 允许荷载

allowable error：許容誤差

816. allowable distance between stations 許容局間距離 | 817. allowable error 許容誤差 | 818. allowable oil pressure 許容油圧

average allowable error：平均容许误差

average 平均 | average allowable error 平均容许误差 | average closing error 平均闭合差