aldehyde resin

aldehyde resin的基本解释

-

[医] 醛树脂

与aldehyde resin相关的网络例句 [注：此内容来源于网络，仅供参考]

Our company has six sets of polyketone resin production equipment, three sets of aldehyde resin production equipment and five sets of UV oligomers production equipment, with annual capacity of 2,500-ton polyketone, 1,000-ton aldehyde resin, and 4,000-ton UV oligomers, and is one of the largest manufacturers of aldehyde resin , polyketone resin and UV oligomers in Asia.

有六套聚酮树脂、三套醛树脂、五套UV光固化树脂生产装置，年产聚酮2，500吨，醛树脂1，000吨，UV光固化树脂4，000吨，是亚洲最大的醛树脂、聚酮树脂、UV光固化树脂生产企业之一。

The effects of solution\'s pH value, mol ratio between phenyl aldehyde and L-Arginine, concentrations of sodium chloride, ammonia chloride andL-Lystine, initial concentration of L-Arginine on precipitation rate of a -tolylene arginine were investigated, the results indicated that phenyl aldehyde precipitation method\'s appropriate pH value was higher than 11, suitable mol ratio between phenyl aldehyde and L-Arginine was 1.25, initial concentration of L-Arginine was must higher than 15g/L, sodium chloride had little effect on precipitation rate, on the contrary, ammonia chloride and L-Lystine had great effect on it, both of them must be eliminated; At the same time, adsorption isotherm at 25 C of L-Lystine on anion exchange resin A was measured, the result showed that the maximal equilibrium adsorbance was 30mg/g, the influences of solution\'s pH value, temperature, concentration of chloride ion on adsorption of L-Lystine by anion exchange resin A were also studied, the results indicated that appropriate operational pH value was 0.5 0.2, the effect of temperature on adsorption ratio was little, process could be operated at room temperature, the concentration of chloride ion must be eliminated.

考察了溶液pH值、苯甲醛与L-精氨酸摩尔比、氯化钠与氯化铵浓度、L-赖氨酸浓度、L-精氨酸初始浓度对苯甲醛沉淀L-精氨酸的影响，结果表明，沉淀反应的适宜pH值大于11，苯甲醛与L-精氨酸的适宜摩尔比为1.25，(来源：Aa6BC论文网www.abclunwen.com)L-精氨酸适宜的初始浓度在15g/L以上，氯化钠的存在对沉淀率基本上没有影响，而氯化铵和L-赖氨酸的存在使沉淀率下降；同时测定了25℃时阴离子交换树脂A吸附L-赖氨酸的吸附等温线，表明其最大平衡吸附量为30mg/g，考察了溶液pH值、温度、氯离子浓度对阴离子交换树脂A吸附脱除L-赖氨酸的影响，结果显示从L-精氨酸和L-赖氨酸混合液中吸附分离出L-赖氨酸的适宜pH值为10.5±0.2，温度对L-赖氨酸吸附率影响不大，吸附过程可在室温下进行，氯离子的存在使L-赖氨酸的吸附率降低。

Resins: gum dammar; PU dispersion; silicone resin, epoxy resin, alkyd, acrylic Resin, polyester resin, urethane resin, polyamide resin, amino hardener; two pack hydroxy acrylic, two pack isocyanate-free acrylic; vinyl chloride co-polymers, polyvinyl butyrals, thixotropic resin.

树脂类：达玛树脂；水性PU分散体；有机硅、环氧、醇酸、丙烯酸、聚酯、聚氨酯、聚酰胺、氨基固化剂；双组份羟基丙烯酸、双组份不含异氰酸脂丙烯酸；聚氯乙烯共聚物、聚乙烯醇缩丁醛、触变性树脂。

与aldehyde resin相关的网络解释 [注：此内容来源于网络，仅供参考]

aldehyde resin：聚醛尸

aldehyde dehydrogenase 醛脱氢酶 | aldehyde resin 聚醛尸 | aldimine 亚胺醛

aldehyde resin：聚醛树脂

alcyone days 平安时间 | aldehyde resin 聚醛树脂 | aldehyde 醛

aldehyde resin：聚醛树腊

aldehyde 醛 | aldehyde resin 聚醛树腊 | algicide 灭藻剂

Phenol aldehyde resin：酚醛树脂胶

Penetrant 渗透剂 | Phenol aldehyde resin 酚醛树脂胶 | Polishing varish 擦光(亮)清漆

Phenol aldehyde resin：酚醛树脂, 苯酚醛树脂

tail lamp socket 尾灯插[座] | phenol aldehyde resin 酚醛树脂, 苯酚醛树脂 | annomination 类语重叠