air sleeve

air sleeve的基本解释

-

风向袋

-

风标

与air sleeve相关的网络例句 [注：此内容来源于网络，仅供参考]

The experiment results prove that the boiler coking is largely reduced and the temperature difference of two sides of horizontal gas-pass is very small, when the 330MW boiler operate, the pressure of primary hot air parison is controlled beyond 12.0～12.5KPa, the O2 content of air pheheater is controlled about 3.0%, the door of OFA is opened to 30%, the buffle of the inner secondary air sleeve is adjusted to the minimum, the outer secondary air swirling strength and the baffle of the outer secondary air sleeve is regulated to the maximum and the outlet temperature of pulvervised mill is kept in 70℃.

试验结果表明，330MW运行时，一次热风母管压力控制在12.0～12.5kPa以上、空气预热器实际氧量控制在3.0％左右、燃尽风门开至30％、内二次风量套筒挡板调整在最小、外二次旋流强度和外二次风套筒挡板调整到最大、磨煤机出口温度维持在70℃，此时锅炉结焦大幅度减轻，水平烟道两侧烟温差非常小。优化试验完成后，进行了单烧灵武烟煤对比，结果是：掺烧高灰熔点的银北煤后，炉膛结焦大幅度减轻，锅炉过热器减温水量较小，主蒸汽压力易提高，带负荷能力正常；再热器烟气挡板开度较大、减温水量较小；风机电耗较小。

Full-length appropriate to the length of the surge in air slit on the sleeve?

全长的适宜以全长的急速上升空气缝上袖子？

Use MINIMUM air pressure to extend sleeve life.

采用最小气压可以延长套管使用寿命。

The differential locks by the compressed air in cylinder pushing joint sleeve.

差速锁的锁止是通过气缸压缩空气推动接合套实现。

The operation conditions in these stages have influence on the flow patterns of molten metal and the air entrapment in the shot sleeve .

低速压射过程中冲头的运动分为封闭浇料口、匀加速和匀速低速三个阶段，各个阶段的工艺参数对压室内金属液的流动形态都有重要作用，进而影响铸件中气孔缺陷的产生。

与air sleeve相关的网络解释 [注：此内容来源于网络，仅供参考]

air sleeve：风(向)袋

air pressure test,空气压力试验 | air sleeve,风(向)袋 | air temperature,气温

air sleeve：风(向)袋PCB用基材词汇中英文对照

air pressrue balance,空气压力天平 | air pressure test,空气压力试验 | air sleeve,风(向)袋PCB用基材词汇中英文对照

air sleeve：风向袋, (圆锥形)风标

air slaking || 潮解, 风化 | air sleeve || 风向袋, (圆锥形)风标 | air slide valve || 空气分配阀

air sleeve：风(向)袋 PVc中国学习动力网

air pressure test,空气压力试验 PVc中国学习动力网 | air sleeve,风(向)袋 PVc中国学习动力网 | PVc中国学习动力网

air guide sleeve：导流罩

air guide section || (发动机)导气段 | air guide sleeve || 导流罩 | air gun || 气枪, 空气枪