adjusting nut

adjusting nut的基本解释

-

调整螺母

与adjusting nut相关的网络例句 [注：此内容来源于网络，仅供参考]

Adjusting the packing 1 Pump packing (1) continue to hand tighten the squeeze cap nut;(2) after opening the pump, adjust the gland nut, this time to allow a little more leakage;(3) slowly tighten the squeeze cap nut, gradually reduce the leak until the leak to an acceptable level;(4) If the disclosure of a sudden stop, should be back to tighten the gland nut, packing re-adjustment in order to prevent overheating;(5) adjust the leakage rate can reach a steady state.

泵用盘根（1）继续用手拧紧压盖螺母；（2）开泵后，调整压盖螺母，此时截止阀允许有稍多的泄漏；（3）缓慢地拧紧压盖螺母，逐渐减少泄漏，直到泄漏达到可接受的程度；（4）如果泄露突然停止，应回拧压盖螺母，重新调节以防止盘根过热；（5）调节泄漏率达到一个稳定状态即可。

The disk spring fixed on the adjusting nut pushes the screw nut through pressure bearing.

碟形弹簧靠在调节螺母上且经压力轴承分别抵压丝杆螺母。

Pressure valve is of direct action type, which is composed of body, seat, core parts, bonnet, highest quotation, diaphragm, spring, adjusting nut and upper and bottom diaphragm cover etc..

本产品为直接作用型自力式压力调节阀。由阀体、阀座、阀芯部件、阀盖、顶盘、上、下膜盖、膜片、弹簧、调节螺母等零部件所组成。

与adjusting nut相关的网络解释 [注：此内容来源于网络，仅供参考]

Adjusting nut：调整螺母

Adjusting lever 调整杆 | Adjusting nut 调整螺母 | Adjusting shim 调整垫片

Adjusting nut：蝶螺母

adjusting gauge 蝶量规 | adjusting nut 蝶螺母 | adjusting screw 蝶螺钉

Adjusting nut：調整螺帽

"调整针","adjusting needle" | "调整螺帽","adjusting nut" | "调整面","adjusting plane"