abrasion [ə'breiʒən]

abrasion的基本解释

n.

磨损, 磨损处, 磨损之处, 磨减

abrasion的同义词

n. attrition · detrition

与abrasion相关的网络例句 [注：此内容来源于网络，仅供参考]

When the parameter matching of the wheel location is improper, namely, the matching between the wheel toe-in and the wheel camber angle is ill-suited, abrasion of the two wheels of the same steering axle is inside or outside simultaneously, because of wheels sideslip. However, when double-front-axle steering system failure take place, abrasion of the two wheels of the same steering axle is in the same side, and that, tyre abrasion direction of front and back steering axles is rightabout. That is to say, if tyre abrasion of front steering axle lie in the left side, tyre abrasion of back steering axle lie in the right side to a certainty, which is the rule of tyre abrasion of double-front-axle steering automobile.

当定位参数匹配不当时，同一转向轴上左右车轮的磨损部位都在内侧或外侧，原因是左右车轮在滚动的同时还要产生相向或反向侧滑；而双前轴转向汽车前、后转向轴引导汽车转向方向不一致时，同一转向轴左、右车轮的磨损部位都在同一侧，而且前、后转向轴上的车轮偏磨损方向正好相反，即如果前转向轴左、右车轮磨损部位在左侧或右侧，那么后转向轴左、右车轮磨损部位就在右侧或左侧，这是双前轴转向汽车特有的轮胎磨损规律。

Secund abrasion is main format of abrasion about double-front-axle steering automobile and is different from secund abrasion caused by the parameter matching of the wheel location improperly.

双前轴转向汽车轮胎磨损的主要形式是偏磨损，这种偏磨损有别于车轮定位参数匹配不当时引起的偏磨损。

In the paper the author relates systematically the research fruits in the program of Research on Sand Slurry Abrasion Mechanisms of Dredging Conditions and New Wear-Resistant Materials. The main contents and innovations are listed as follows.Summarized and analyzed are the wear researches and developments, and the methods of increasing materials wear-resistance. From the viewpoint of the characteristics of two-phase liquid sand slurry wear, combined with the examination and study on easily damaged workpieces, the wear failures basic rules are pointed out, of the pump shell and the cutter-piece on service, and the general principles of material wear-resistant designs put forward. The sand slurry abrasion tester has been designed and developed which can simulate general dredging conditions. Summarized and presented are the position-exchange measuring method of sand slurry abrasion test and the experiment specification of sand slurry wear test of dredging conditions.

文中系统论述了作者在疏浚工况泥沙磨损机理及其耐磨新材料课题研究中的工作成果，主要研究内容和创新点如下：总结分析了磨损研究动态和提高材料耐磨性的方法；从两相流泥沙磨损的特点出发，结合对失效易损件的考察研究，分析指出了现役泥泵壳和绞刀片磨损失效的基本规律，提出了材料耐磨损设计的基本思想；设计研制了能模拟疏浚工况的泥沙磨损试验机，总结提出了泥沙磨损试验换位测试法和疏浚工况泥沙磨损试验规范。

与abrasion相关的网络解释 [注：此内容来源于网络，仅供参考]

abrasion：磨损

为此,据负责风扇和取暖器的UL标准小组的分析报告,UL507风扇标准、UL1278取暖器标准、UL1042固定式发热板标准已先后提出了对软线的新增"-R"要求,即软线需能通过磨损(abrasion)试验、压挤(pinching)试验、压碾(crushing)试验、弯曲(flexing)试验,

abrasion：磨耗

这种铝油漆在使用时,接近薄膜表面的大部份的颜铝颜料的制造,是用一连串的捣碎机 (stamp mill)或鎚碎机 (hammer mill),块或颗粒,打碎成光亮,细小的叶片,便有最少程度的磨耗(abrasion)和研氛防制铝粉的可能爆炸.

abrasion：磨蚀

(1)"洁净"(Clean)钻石:无任何明显的内部瑕疵的钻石.(2)"不洁"(Pigue)钻石:具明显包裹体的较常见钻石.外部的瑕疵统一用绿色笔划,主要有:磨蚀(Abrasion)、多余刻面(Extra Facets)原晶面(Natural)、伤痕(Nick)、小白点(Pit)、磨痕(Pol

abrasion：擦伤

矿物质可通过擦伤(Abrasion)或直接作用(如铜)破坏维生素(所幸的是,除食盐以外,绝大多数矿物质含水量很低). 有些维生素可被光破坏. 核黄素在加工过程中比较稳定;但容易被紫外和可见光破坏. 维生素B6、维生素C和叶酸也可被光破坏.

Abrasion test：磨损试验

磨损 abrasion | 磨损试验 abrasion test | 研磨材料 abrasives