Witt decomposition

Witt decomposition的基本解释

-

维特分解

与Witt decomposition相关的网络例句 [注：此内容来源于网络，仅供参考]

In the one half part, according to the strontium nature, thermodynamic calculation of correlative reaction and the principle of the vacuum aluminothermy reduction process, with the laboratory findings of preparation strontium by vacuum aluminothermy reduction compared and analyzed in different parameter conditions, a variety of factors which effect the decomposition rate of SrCO_3 and the percent reduction of strontia are gotten out. The factors include that the decomposition rate of SrCO_3 is influenced by different addition and pressure. They also include that the percent reduction of strontia is influenced by excess coefficient of reducing agent aluminium powder, the particle size of raw material or reducing agent, the pressure of barbecuing, temperature and reduction time. According to those, we can draw the conclusion as follows:(1) Decomposition temperature of SrCO_3 is decreased by adding carbon and alumina in different degree.(2) With quantitative carbon added under the vacuum condition, the decomposition temperature of SrCO_3 is decreased obviously, which can fall 150℃ compared with atmospheric pressure.(3) In keeping 1150℃ of 2.5h, under the 5Pa vacuum condition, the decomposition rate of SrCO_3 nearly keeps in 99% steadily.

在前半部分的真空铝热还原法中，根据锶的性质、相关反应的热力学计算及真空铝热还原法原理，通过对不同参数条件下的真空铝热还原法生产金属锶的实验结果的分析比较，得出了影响SrCO_3的分解率和氧化锶的还原率的种种因素，具体因素包括不同添加剂、不同气压对SrCO_3分解率的影响，还原剂铝粉的过量系数、原料与还原剂的粒度、制团压力、温度和还原时间等对氧化锶还原率的影响，得出具体结论如下：(1)添加碳和Al_2O_3能不同程度的降低SrCO_3的分解温度；(2)真空条件下加入一定量的碳可显著降低SrCO_3的分解温度，比之常压下可降低150℃之多；(3)在1150℃恒温2.5h、真空度达到5Pa的条件下，SrCO_3的分解率几乎保持稳定在99％；(4)氧化锶的还原率随还原剂过量系数的增大而增大，但是趋势越来越小，当过量系数超过25％后，氧化锶的还原率几乎不再增加；(5)氧化锶的还原率随原料与还原剂的粒度的变细而增加；(6)氧化锶的还原率随制团压力的增加而增加，但超过一定值后，氧化锶的还原率反而会下降；(7)氧化锶的还原率随还原温度的升高而增加；(8)氧化锶的还原率随还原时间延长而增加，在本实验条件下，超过2.5h趋于稳定。

Based on a formal analysis of lifting decomposition, the hierarchical structure concept of the decomposition set, as well as the lifting decomposition technique of the polyphase matrix' greatest mth-order common divisor, is proposed to conquer the difficulties in the practical computation of and the optimal search in the huge decomposition set.

本文在形式化分析Lifting分解原理的基础上，提出了分解集合的分级结构概念以及多相矩阵的m阶最大公因子Lifling分解技术，克服了分解集合求解问题的高复杂性所带来的实际计算与搜索困难；进一步地，从数值稳定性及计算代价两方面研究了分解的评价问题，设计出两种实用的分解稳定性准则；最后，结合分级结构技术提出一种最优分解算法。

The results show that the decalescence of catalyst bed affects the process of hydrogen peroxide catalytic decomposition greatly. If the catalyst bed is preheated or made up of materials with low thermal conductivity, that influence can be depressed. At the same time, the response characteristic of catalyst bed and the efficiency of catalytic decomposition can be improved. The low frequency pressure instability of catalyst bed occurs because of the coupling of catalytic decomposition and supplying. The decomposition plane pushes all the way through the catalyst bed during pressure oscillations, causing unreacted liquid hydrogen peroxide to be exhausted from the bed and leading to the appearance of liquid hydrogen peroxide channeling. Consequently, how to prevent or at least limit this channeling is the key to eliminate the pressure instability of catalyst bed. It was found that adding clapboard to the catalyst bed can depress the pressure instability efficiently.

结果表明催化剂床及催化剂的吸热对过氧化氢分解过程影响很大，对催化剂床进行预热或采用热导率低的材料制造催化剂床等措施，可以降低催化剂床壁面吸热对催化分解过程的影响，提高催化剂床的响应特性和催化分解效率；催化剂床的低频不稳定是催化分解过程与供应系统耦合产生的，催化剂床气体界面的波动过程中，液体过氧化氢穿透催化剂床形成过氧化氢液体通道，过氧化氢液体通道的产生和扩大是催化剂床不稳定的主要原因，也是消除催化剂床不稳定的关键，试验中在催化剂床内加入分流板成功地抑制了催化剂床的低频不稳定。

与Witt decomposition相关的网络解释 [注：此内容来源于网络，仅供参考]

witt decomposition：维特分解

within group variance 群内分散 | witt decomposition 维特分解 | word 字