Cavitated

Cavitated的基本解释

-

[医]腔形成

与Cavitated相关的网络例句 [注：此内容来源于网络，仅供参考]

Cavitation erosion is related to bubbles.Bubbles pop out from drilling fluid in vacuum conditiun and form air mass against cyclinder well.For low resistance to pressure,air mass happen explosion when compressed,making cyclinder wall cavitated.

气蚀发生的条件与气泡密切相关，气泡在真空时从钻井液中溢出形成气团，并紧靠缸壁；气团在压缩时因承压能力低而产生爆炸，从而引起缸壁产生气蚀作用。

The cavitated bifurcation equation that describes cavity formation and growth in the interior of the sphere is obtained. It is proved that there exists a unique bifurcation point on the trivial solution of the cavitated bifurcation equation.

本文利用分岔理论和动力学理论中的基本观点、方法和结论，对具有缺陷的超弹性材科组成的球体内部的空穴生成和增长的拟静态问题以及空穴生成后随时间的运动规律等方面进行了系统的研究，得到了一些新的结论，同时给出了相应的数值分析。

In contrast to the situation for a homogeneous isotropic neo-Hookean sphere, it is shown that not only there exists a secondary turning bifurcation point on the cavitated bifurcation solution which bifurcates locally to the left from trivial solution, and also the critical load is smaller than that for the material with no perturbations, as the parameters belong to some regions.

与均匀各向同性的neo-Hookean球体的情况相比，证明了当摄动参数属于某些区域时，从平凡解局部向左分岔的空穴分岔解上存在一个二次转向分岔点，空穴生成时的临界载荷会比无摄动的材料的临界载荷小。

In Chapter 4, problems of cavitated bifurcation for two spheres, which are composed of two different kinds of imperfect compressible hyper-elastic materials, were examined, respectively.

以一类具有缺陷的不可压超弹性材料组成的球体为例，研究了材料缺陷对空穴运动方程的非平凡解的存在性及其定性性质的影响。

It is suggested to weld and apply anti-abrasion-cavitation material on seriously cavitated area, obvious result has been abtained.

对气蚀严重部位，建议采用高强度抗磨焊条补焊及喷涂抗磨材料，实施后效果显著。

与Cavitated相关的网络解释 [注：此内容来源于网络，仅供参考]

cavitated bifurcation：空穴分岔

分岔分析法:bifurcation | 空穴分岔:cavitated bifurcation | 分岔理论:bifurcation theory